SEAWORKS (Vanuatu), Main Street, Nambatu, P.O. Box 3242 Port Vila – Phone +678 7100 230 (WhatsApp)
SEAWORKS (New Caledonia), BP 7036 – 98801 Noumea Cedex – Phone +687 87 55 05
We operate throughout Oceania Islands, with the capacity to stay working at remote locations
Complete Diving Services to Vessels & Civil Engineering Industry
Corrosion Inspection
Corrosion surveys are essential to any inspection programme. As steel and salt water are very corrosive combination, much attention is directed to the problem.
They are many different types of corrosion, each produced by different causes. They may occur alone or simultaneously.
Some of these types are listed below:
The two that are the most interesting to the diver
General corrosion
(an even loss of metal)
Pitting corrosion
(localised areas of concentrated metal loss).
The present engineering approach to these problems has two prime aspects:
- To built-in at the design stage, an extra thickness of steel as a corrosion ‘allowance’, normally about 20-30 mm in the splash zone.
- To attempt to prevent corrosion. The main protection methods are cathodic protection (sacrificial anode, impressed current) and protective coatings (electrically insulating cover).
Corrosion inspection has three important objectives:
I.
To find out if the corrosion protection systems are actually working, by checking:
- That the coating is intact
- That the coating remains bonded to the steel
- That the anodes are still in place
- That the electrical circuit still exists between the anode and the structure (check continuity strap)
- That the electrical potential between the structure and the seawater is adequate by comparison against a reference half-cell indication, using a CP meter.
II.
To find and measure corrosion damage by:
- Measuring the thickness of steel for general corrosion, using ultrasonic thickness meters, commonly called ‘D’ meters
- Measuring the extent and depth of pitting corrosion, using pit gauges
III.
To help plan the maintenance of corrosion protection systems by:
- Measuring the dimensions of anodes to find the rate of erosion and thereby estimate the remaining life of an anode
- Assessing the condition of the protective coating to find out if and when maintenance is required.
We can provide you with thickness of steel measure, without the need to remove coating (use of multiple echo) and even on the most heavily corroded metals.